I am trying to install a NM-ESW-16 into a 2610 router. The router is running IOS 12.3 (21). When I do a SH DIAG is shows that in Slot 1 and UNKNOWN (type 681) PORT ADAPTER. Further down it gives additional information, such as harware revision, serial number, and shows that the Product Number is NM-16ESW.
Any idea why this device does not show up when I do a SH IP INT? Is there some additional installation/configuration that I need to perform to enable this device?
Yes, I have removed and reseated this module. When the router boots up the lights come on and then go out after the POST is completed.
Cisco Etherswitch Modules are supported in IP Plus or above in Cisco IOS releases 12.2T. Beginning with Cisco IOS 12.3 Mainline and 12.3T, the Cisco Etherswitch modules are supported in IP Base or above.
I'll take a wild guess that this module is not supported on the 2610, let me check it out.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...