Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2611 Configuration

I recently acquired a used 2611 (which I've since had all previous configurations cleared) and need to set it up between two networks. Like this:

Network 1: 192.168.144.100/255.255.0.0

Network 2: 10.20.30.100/255.255.0.0

I need to be able to configure the router to allow network 2 to send to network 1, but restrict network 1 from sending to network 2.

I have configured the two interfaces with the appropriate IP addresses (looks correct with "show interfaces" command), but I'm not quite sure how to set up the rest of it. Also, the router continues to echo to the terminal a lot of errors related to config files or something similar.

Can anyone help me out on this?

Thank you.

3 REPLIES
New Member

Re: 2611 Configuration

New Member

Re: 2611 Configuration

The errors are...

%Error opening tftp://255.255.255.255/network-confg (Timed out)

*Mar 1 07:31:31.297: %SYS-4-CCONFIG_RESOLVE_FAILURE: System config parce from (tftp://255.255.255.255/network-confg) failed

Other errors (replace "network-confg" above)

cisconet.cfg

2611-confg

2611.cfg

As for the link you provided, for whatever reason, my password is not working. Any ideas?

Thanx again.

New Member

Re: 2611 Configuration

these errors are no harm.

do this at the global config mode "no service config"

if you have cco you can search for "reflexive access list"

118
Views
0
Helpful
3
Replies
CreatePlease to create content