cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
527
Views
0
Helpful
3
Replies

2611 Configuration

stmasi541
Level 1
Level 1

I recently acquired a used 2611 (which I've since had all previous configurations cleared) and need to set it up between two networks. Like this:

Network 1: 192.168.144.100/255.255.0.0

Network 2: 10.20.30.100/255.255.0.0

I need to be able to configure the router to allow network 2 to send to network 1, but restrict network 1 from sending to network 2.

I have configured the two interfaces with the appropriate IP addresses (looks correct with "show interfaces" command), but I'm not quite sure how to set up the rest of it. Also, the router continues to echo to the terminal a lot of errors related to config files or something similar.

Can anyone help me out on this?

Thank you.

3 Replies 3

situwayne
Level 1
Level 1

The errors are...

%Error opening tftp://255.255.255.255/network-confg (Timed out)

*Mar 1 07:31:31.297: %SYS-4-CCONFIG_RESOLVE_FAILURE: System config parce from (tftp://255.255.255.255/network-confg) failed

Other errors (replace "network-confg" above)

cisconet.cfg

2611-confg

2611.cfg

As for the link you provided, for whatever reason, my password is not working. Any ideas?

Thanx again.

these errors are no harm.

do this at the global config mode "no service config"

if you have cco you can search for "reflexive access list"

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco