Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2800 router connected to a 2950 or 2960 switch

What I have been seeing is a site will loose power and then after the equipment is back up the E/N switch port will be blowing errors. The only way I have been able to clear this is by resetting the switch. Any suggestions.

1 REPLY

Re: 2800 router connected to a 2950 or 2960 switch

Hi Simmons

When the power goes off is your Switch still on and working ?

Also not sure about E/N switch port as you have mentioned over here..

What about the other end of the switch port ?

Did you try monitoring the other end too ?

regds

135
Views
0
Helpful
1
Replies