Configured Cat 3560 switch with vlans and interroutes. Vlan communication happens perfectly. I have a 2801 series router which is connected to fa 0/47 port on the switch and is in another vlan. From the switch i can reach the router and vice-versa. But i am not able to reach the router from any of the clients from any Vlans. I can successfully reach all other desktops on any vlans. All client machines are directly connected to 3560.
Note: If i connect a PC to the same vlan as 2801, am able to reach.
Could any one please help me to find the solution to reach the router from any vlan.
Your other VLANs are using different subnets other than 10.40.130.0/24 (be aware of your subnetmask) and thus to reach them back your router needs either a static route for each (10.40.90.0, 10.40.100.0, 10.40.110.0 and 10.40.120.0) or simply have a default route, it is the same concept that your PCs have their default gateway.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...