I have four ADSL lines and I want to setup my 2801 to do pbr according to source ip. I have 4 linux routers doing the pppoe to our isp but I would like to have the 2801 doing the pppoe and the pbr to eliminate the linux routers. Can I trunk from the 2801 to a 2960 switch configure 4 vlans plug in the adsl modems directly to the switch and have the 2801 doing the pppoe? Or do I have to have an hwic-4esw?
If this is possible how would I configure the pppoe connections?
I have the trunk working as well as the pbr config working.
The following document shows how to configure a Cisco 1700 using the Ethernet WAN Interface Card (WIC-1ENET) to act as a Point-to-Point Protocol over Ethernet (PPPoE) client with Network Address Translation (NAT).
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...