Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2801 QoS on FE port

I'd like to know if this is suported and I can't find the answer online.

1)I can't set dscp with an outgoing policy on FE interface

2)Configuring dot1Q in FE the value of CoS (layer 2) is not being mapped, it's always 0, without takinf care of dscp value.

1 REPLY
Silver

Re: 2801 QoS on FE port

try this in global config mode:

policy-map mark-traffic

class crtical-traffic

set ip dscp cs5

class non-critical-traffic

set ip precedence 2

within particular vlan interface

service-policy input mark-traffic

169
Views
0
Helpful
1
Replies
CreatePlease to create content