05-30-2007 08:11 AM - edited 03-05-2019 04:22 PM
If I install the 9ESW Switch Module in a 2801 can it become another network?
For example, I want one network on Eth1, a second network on Eth2 and third network on the switch module. I want to route between the three networks.
05-30-2007 08:17 AM
Steve
With appropriate configuration of VLANs I would think it was quite possible. I have not tried to do this on that platform so I can not speak from experience. But I would think it was quite possible.
HTH
Rick
05-30-2007 08:17 AM
Yes, you can do that. You have to create L3 SVI's on the router and then assign the respective port to each vlan. You cannot create each interface as a Layer3 interface by giving it an IP address directly.
http://www.cisco.com/en/US/products/ps5854/products_qanda_item0900aecd8016c026.shtml
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a0080684bf5.html
HTH,Please rate if it does.
-amit singh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide