Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 E1 Card

I have cisco 2811 with VWIC-2T1/E1-RAN installed. I have IOS

(C2800NM-IPVOICE-M), Version 12.4(18)

But it is not recognizing the E1 card.even card router is not recognizing the card type command.

WIC Slot 0:

Unknown WAN daughter card

WIC module not supported/disabled in this slot

Hardware Revision : 3.0

Top Assy. Part Number : 800-25833-03

Board Revision : E0

Deviation Number : 0-0

Fab Version : 02

PCB Serial Number : FOC11302ZTB

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Version Identifier : V01

Product (FRU) Number : VWIC-2T1/E1-RAN

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 04 BF 41 03 00 C0 46 03 20 00 64 E9 03

Please tell me which IOS will support these commands.

2 REPLIES

Re: 2811 E1 Card

You should be using the ITP release for your 2821. The use of the VWIC-2T1/E1-RAN requires Cisco IOS Software Release 12.4(11)SW1 or later. The latest version is 124-11.SW3.bin.

Mark

Re: 2811 E1 Card

400
Views
0
Helpful
2
Replies
CreatePlease login to create content