Hi, i have 2811 ISR where i am creating sub interface vlans on the routing ports. i have inserted an 4ESW module where i would like those sub interface vlans to terminate. Is there a way of getting getting data out of a subinterface vlan and foward it to a vlan created in the 4ESW module (without the use of irb bridging)?
To use the switch modules you create the layer 2 vlans in the vlan datatbase , then you create a layer 3 SVI's to handle the layer 3 end of things like you would on any other l2/3 switch . You would not use subinterfaces if you are going to try and route on the switchports , don't believe addresses are allowed on the switchpoirt interfaces you must use SVI's then put the switchports into that vlan.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.