Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2811 with two HWIC-4ESW and native ports in same VLAN

I have a 2811 with two HWIC-4ESW installed in "stacket" mode and i would like to know if there is any way to configure the native Fastethernet port in the same VLAN used on the HWIC's ports, using the same ip network ?

1 REPLY
Gold

Re: 2811 with two HWIC-4ESW and native ports in same VLAN

This is one I have been want to test for some time now. It seem every time I get a 4esw it has to be in production now. The site that had this requirement changed and so I never found out for sure.

My theory on how to make this work is to put a bridge group on both the vlan interface and the physical port. You then put in a BVI for the bridge group to do the routing. This is the same configuration you would use when you bridge the 2 internal ports together but in this case you bridge it to the vlan.

Will it work I don't know. It will take the commands but I never had a chance to test.

If you do attempt this can you post your findings.

160
Views
0
Helpful
1
Replies