I can't seem to figure out how to fix this probelm. Each time I try to boot the system I always end up in the boot command prompt "switch:". I've tried boot flash, removing directories/files but I keep getting a "permission denied" message. I've also tried reinstalling a new IOS image onto the switch using xmodem, and at the last minute I get a message that says there isn't enough space to install the IOS image. Whatever else I do to the switch denies my permission to go any further. How can I go about without constantly getting these permission denied messages?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.