I am VERY new to both Cisco routers AND terminal configuration, but I am not completely ignorant and have been able to configure the interfaces on our 2911 router.
The problem I am having is with setting the username and password for the system (i basically dont know how). I can still get logged on (I have to boot without the flash card and replace it after its booted, but it works to get me logged in to configure the system)... SO>> with that being said- how, once I am logged in how do I configure the login credntials?
There are several potential answers to the question of how you configure the login credentials and most of them begin with "it depends". It depends on whether you have configured aaa new-model and further depends on how you want it to work:
- with no aaa new-model configured you should be able to access the console port without any credentials configured (to access user mode).
- with no aaa new-model configured you can configure passwords that will allow remote access to the router that will get you to user mode access. the config might look something like this
line vty 0 5
- with no aaa new-model configured you may want to configure user accounts and passwords that will get you to user mode access. the config might look something like this
line vty 0 5
- or you can use more sophisticated processing of user credentials using aaa new-model. But explanation of this functionality probably goes beyond the scope of this post.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...