I'm currently runing a 2911 router using RITE to export traffic out a fortinet 80CM. The router will eventually crash after an undetermined time giving the error bus error at PC 0x35DC0240, address 0xF3.
I'm currently running 15.2(4)m6a because cisco shows it as stable. I'm wondering if upgrading to 15.4(3)M would fix my problem. I'm also under the understanding that 2911 and 2921's support the RITE function.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...