Dear Experts ,
I would like to know whether the following switch supports trunking or not ?
Switch model: WS-C2912-XL-A
CS01#sh version
Cisco Internetwork Operating System Software
IOS (tm) C2900XL Software (C2900XL-C3H2S-M), Version 12.0(5)WC7, RELEASE SOFTW
E (fc1)
Copyright (c) 1986-2003 by cisco Systems, Inc.
Compiled Wed 05-Mar-03 10:26 by antonino
Image text-base: 0x00003000, data-base: 0x0034DEE8
ROM: Bootstrap program is C2900XL boot loader
CS01 uptime is 1 hour, 10 minutes
System returned to ROM by power-on
System image file is "flash:c2900xl-c3h2s-mz.120-5.WC7.bin"
cisco WS-C2912-XL (PowerPC403GA) processor (revision 0x11) with 8192K/1024K by
s of memory.
Processor board ID FAB0409T13W, with hardware revision 0x01
Last reset from power-on
Processor is running Enterprise Edition Software
Cluster command switch capable
Cluster member switch capable
12 FastEthernet/IEEE 802.3 interface(s)
32K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address: 00:01:42:DC:D9:80
Motherboard assembly number: 73-3397-08
Power supply part number: 34-0834-01
Motherboard serial number: FAB040844KT
Power supply serial number: PHI033901TY
Model revision number: A0
Motherboard revision number: A0
Model number: WS-C2912-XL-A
System serial number: FAB0409T13W
Configuration register is 0xF
When i enable trunking on f0/11 of switch it is taking commnds neccessary for config.
Trunk link is not working means it is not allowing any vlan traffic.
From below doc i understand that -A model switches doesn't support trunking where as -EN suppoerts...Is it true ?
http://www.cisco.com/en/US/docs/switches/lan/catalyst2900xl_3500xl/releasesa4/icg/maoverv.html
Thanks,
Satish
