Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2924 CL Switch - Telnet Access

I'm able to access the remote switch via HTTP. However, I can't access it using HyperTerminal. My PCs IP is in the "ip http access-class 2" Access-List.

Here is the VTY setting on the switch. Any Ideas???

line con 0

exec-timeout 0 0

transport input none

stopbits 1

line vty 0 4

access-class 2 in

exec-timeout 30 0

password <Removed>

login

line vty 5 15

access-class 2 in

exec-timeout 30 0

password 7 <Removed>

login

transport input telnet

6 REPLIES

Re: 2924 CL Switch - Telnet Access

Does it work if you remove access-class from the line? Can anyone else telnet to it that's in the list?

HTH,

John

HTH, John *** Please rate all useful posts ***
New Member

Re: 2924 CL Switch - Telnet Access

I'll give it a try. I'll remove it from both vty 0 4 and vty 5 15.

New Member

Re: 2924 CL Switch - Telnet Access

Here is what is showing on the Configuration now and still no luck accessing the device using HyperTerminal. I get the following error: "Unable to connect to XXX.XXX.XXX.62 port 23". My "HT" emulation is Auto detect.

****************************************

line con 0

exec-timeout 0 0

transport input none

stopbits 1

line vty 0 4

exec-timeout 30 0

password

login

line vty 5 15

exec-timeout 30 0

password 7

login

transport input telnet

Hall of Fame Super Gold

Re: 2924 CL Switch - Telnet Access

Try using the DOS command "telnet" instead of using HyeperTerminal.

New Member

Re: 2924 CL Switch - Telnet Access

Tried that and the same results.

Hall of Fame Super Gold

Re: 2924 CL Switch - Telnet Access

Have you tried other machines? Could be a firewall.

340
Views
0
Helpful
6
Replies