Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2924 port security sticky

ok im trying to set my FastEth port 3 into sticky security, but when i go to enter commands this is what i get:

BasementSwitch>en
Password:
BasementSwitch#config t
Enter configuration commands, one per line.  End with CNTL/Z.
BasementSwitch(config)#int fa0/3
BasementSwitch(config-if)#switchport access?
  access    Set access mode characteristics of the interface
  mode      Set trunking mode of the interface
  multi     Set characteristics when in multi-VLAN mode
  priority  Set 802.1p priorities
  trunk     Set trunking characteristics of the interface
  voice     Voice appliance attributes
BasementSwitch(config-if)#switchport access vlan 1
BasementSwitch(config-if)#switchport port-security ?
% Unrecognized command

can someone help me with this, thanks.

4 REPLIES
VIP Super Bronze

Re: 2924 port security sticky

This is what you should see after ?

Management-Switch(config-if)#switchport port-security ?
  aging        Port-security aging commands
  mac-address  Secure mac address
  maximum      Max secure addresses
  violation    Security violation mode
 

Management-Switch(config-if)#switchport port-security

maybe port securiy in not supported

New Member

Re: 2924 port security sticky

yea w

hen i boot it says i downloaded the LRE image, im downloading the non  LRE and hopefully that will help

VIP Super Bronze

Re: 2924 port security sticky

be careful

LRE image may not work on a regular 2924

New Member

Re: 2924 port security sticky

yea i just nopticed at boot it says that my 2924XL isnt LRE compatable, so i am re uploading a non LRE

956
Views
0
Helpful
4
Replies
CreatePlease login to create content