I recently purchased a secondhand 2924XL switch and I've not been able to get in through the console port. I've not seen any output from it at all with a rollover cable that works fine on my 2600 router.
So far I have tried:
Using every speed from 115200 to 110
Hardware flow control on, and off
Xon/Xoff flow control (on and off)
I have been able to telnet in, but that's of little use without the passwords. Is there any other way of resetting it?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.