Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950 Cisco Catalyst Switch

Was wondering if a Catlayst 2950 can SPAN the G0/1 and G0/2 ports as well as all the 10/100 Ethernet Ports.

Shaun

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 2950 Cisco Catalyst Switch

Yes, you can use it, that should not be a problem.

Regards,

~JG

3 REPLIES

Re: 2950 Cisco Catalyst Switch

Shun,

You can have only one destination port.

?The destination port cannot be a source port; a source port cannot be a destination port.

?You can have only one destination port.

?For SPAN source ports, you can monitor sent and received traffic for a single port or for a series or range of ports.

It can have only one active SPAN or RSPAN source (rx, tx, both).

Hope that helps

Regards,

~JG

New Member

Re: 2950 Cisco Catalyst Switch

Thanks, Yeah I am aware that I can only have 1 session with a 2950 Series Switch. I just needed confirmation that I can use the Gibabics ports as source ports. I will be using E1/1 for my Snort box/destination port.

Thanks

Shaun

Re: 2950 Cisco Catalyst Switch

Yes, you can use it, that should not be a problem.

Regards,

~JG

129
Views
0
Helpful
3
Replies