Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950 EI ios

which IOS can anybody suggest for 2950 EI

which will support "mls qos" command

4 REPLIES
Cisco Employee

Re: 2950 EI ios

Hi Sanjoy,

Can you update exactly which switch mode do you have or can you paste the "sh version"?

If you already have 2950 EI switch then it should support QOS commands?

Regards,

Ankur

New Member

Re: 2950 EI ios

sh ver

Cisco Internetwork Operating System Software

IOS (tm) C2950 Software (C2950-I6Q4L2-M), Version 12.1(22)EA10, RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2007 by cisco Systems, Inc.

Compiled Tue 08-May-07 11:50 by myl

Image text-base: 0x80010000, data-base: 0x8056C000

ROM: Bootstrap program is C2950 boot loader

Switch uptime is 14 minutes

System returned to ROM by power-on

System image file is "flash:/c2950-i6q4l2-mz.121-22.EA10.bin"

cisco WS-C2950-24 (RC32300) processor (revision B0) with 20970K bytes of memory.

Processor board ID FOC0533X1AM

Last reset from system-reset

Running Standard Image

24 FastEthernet/IEEE 802.3 interface(s)

32K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address: 00:07:50:16:15:00

Motherboard assembly number: 73-5781-13

Power supply part number: 34-0965-01

Motherboard serial number: FOC053300UU

Power supply serial number: PHI052902MP

Model revision number: B0

Motherboard revision number: A0

Model number: WS-C2950-24

System serial number: FOC0533X1AM

Configuration register is 0xF

Switch#

Re: 2950 EI ios

Hi,

This switch WS-C2950-24 can only run SMI and not capable to run EMI.

Cisco IOS is very intelligent, even if you install EMI onto a WS-C2950-24 switch, it will only install SMI code.

HTH,

Shaheen

Cisco Employee

Re: 2950 EI ios

Hi Sanjoy,

2950 model switch which you have will only run standard image and cannot be upgraded to enhanced image but this does not mean it will not support QOS. It will suppor tbut yes not all advance features.

You can have a look at this link which will tell you what all qos features can this switch support running SI image.

http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/release/12.1_20_ea2/configuration/guide/swqos.html#wp1072297

http://www.cisco.com/en/US/tech/tk389/tk813/technologies_q_and_a_item09186a00804976d3.shtml#qa1

HTH

Ankur

*Pls rate all helpfull post

269
Views
0
Helpful
4
Replies