Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950 - Loopback error

I get a LOOPBACK error message on my 2950 switch which disables the port. What should I check for ? I have no idea where to start. Whats causing this?

2 REPLIES
Hall of Fame Super Bronze

Re: 2950 - Loopback error

Can you please post the exact error and also the output from typing

show interfaces status err-disabled

Re: 2950 - Loopback error

There was a bug filed but it was junked, because it is mostly caused by a STP loop or bad cabling. The following bug more details on this

http://www.cisco.com/cgi-bin/bugtool/onebug.pl?bugid=CSCea46385

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat3750/12220se/3750smg/msg_desc.htm#wp98430

You might also want to consider err-disable recovery. You can enable it using

2950-A#conf t

Enter configuration commands, one per line. End with CNTL/Z.

2950-A(config)#errdisable recovery cause loopback

HTH, rate if it does

Narayan

375
Views
0
Helpful
2
Replies