Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2950 lost IOS ??

Hi

Something wrong with a 2950 when I boot it went to switch:

Then I tried this command

switch: flash_

Initializing Flash...

flashfs[0]: Checking block 4...bad block number (12)

flashfs[0]: erasing block 4...done.

flashfs[0]: Checking block 5...bad block number (13)

flashfs[0]: erasing block 5...done.

flashfs[0]: Checking block 6...bad block number (14)

Error message says" Bad block...", does that means the flash disk is broken? If not, how can i upload a IOS in this mode?

Thanks

  • LAN Switching and Routing
1 REPLY
New Member

Re: 2950 lost IOS ??

you could try to use xmodem via console to upload a new image(if there is room).

115
Views
0
Helpful
1
Replies