2950 lost IOS ??

[rico_hao40]

Hi

Something wrong with a 2950 when I boot it went to switch:

Then I tried this command

switch: flash_

Initializing Flash...

flashfs[0]: Checking block 4...bad block number (12)

flashfs[0]: erasing block 4...done.

flashfs[0]: Checking block 5...bad block number (13)

flashfs[0]: erasing block 5...done.

flashfs[0]: Checking block 6...bad block number (14)

Error message says" Bad block...", does that means the flash disk is broken? If not, how can i upload a IOS in this mode?

Thanks

[d_ferraro]

you could try to use xmodem via console to upload a new image(if there is room).