Currently im trying to configure my 2950 to get out to the internet thru my 2600 series router.
I configured the routes on the 2600 the my cabel modem and i am able to ping out to websites from my 2600. I am trunking over to my 2600 and have my default gateway set for my router, what else am i missing to be able to get out to the Internet from my switch.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...