Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2950 QOS problem

Hi dear all,

I want to limit throuput and limit tranfer rate into 16K on L2 cisco switch?

any L2 device suggestion or solution?

3 REPLIES
Cisco Employee

Re: 2950 QOS problem

Hi Emadehsan,

You have to use polocing/rate-limiting on 2950 to acheive the same.

http://www.cisco.com/univercd/cc/td/doc/product/lan/cat2950/12122ea5/2950scg/swqos.htm

HTH

Ankur

*Pls rate helpfull post

New Member

Re: 2950 QOS problem

sho ver of switch pls

Bronze

Re: 2950 QOS problem

Hello,

We get this question a lot in TAC, and the answer is that the 2950 can only police in 1 Mbps increments on fastethernet ports.

The URL is here:

http://www.cisco.com/application/pdf/en/us/guest/netsol/ns432/c649/ccmigration_09186a008049b062.pdf

Section 2-20 at the top of the page mentions this point. It is also a good design guide for deploying QoS too.

Hope this helps,

Michael

Cisco TAC - LAN Switching

152
Views
5
Helpful
3
Replies
CreatePlease to create content