Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2950 restart automatically every 2 min

I have 2950-24 non-LRE switch.I have isolated the switch and powerd on.This is wat i found...

All LEDs were Green for a minute...Then Stat LED was Alternate Green /Amber for 2 sec(where all other LED was Amber)Then all LED went Amber except UTIL,which was green and restart after this sequence....Can you please tell me wat may b the cause?Is there any problem in Hardware?As i cant connect it to Pc'c to find any configuration fault... or is it some kind of bug.....

Please show some light on it....

Actually the above post is the continuation of "2950 blinks amber"

  • LAN Switching and Routing
7 REPLIES
Bronze

Re: 2950 restart automatically every 2 min

Hi,

To better understand your problem you need to connect to the switch thru console n capture all the boot process log and upload here. It will help the Pros to analyze the problem.

HTH

*aijaz*

New Member

Re: 2950 restart automatically every 2 min

Thank u aijaz,

But the switch reboot every 3 min....

How to capture the boot sequence if this is the case?

I can use console and Hyper terminal to enter switch configurations...later how to capture the boot sequence ?

lookin forward to c ur reply,

Silver

Re: 2950 restart automatically every 2 min

Hi Sakthi

If you have your laptop/PC connected to the console port of the switch with a hyper terminal window open, you should see the boot messages come up on the screen every time the switch reboots.

Just capture these messages while the switch is booting and post them here along with the output of show run if you can.

Best Regards,

Michael

Bronze

Re: 2950 restart automatically every 2 min

Hi,

In the hyper terminal menu/ Transfer /Capture Text, select a new text file here/then click start...it will capture all the data till you stop it. Then you can upload the text file here.

HTH

*aijaz*

New Member

Re: 2950 restart automatically every 2 min

Hi aijaz,

Here i hav attached the text file....i came to know it is crashed but...wats the reason? an dwat sud i do to fix it?waiting fo rur reply....

thank u in advance

Bronze

Re: 2950 restart automatically every 2 min

Hi,

AFAIK this is related to the hardware/data bus problem. You need to check with your vendor.

Lets also wait for experts advice..

BR

*aijaz*

New Member

Re: 2950 restart automatically every 2 min

Hi Aijaz,

How to analyse the captured report?and wat is AFAIK means?Can u tell me something abt this?

201
Views
0
Helpful
7
Replies