I have setup the switch below via the console port, with 3 vlans on it, port 1 is a trunk, port 2-4 vlan 2, port 5-11 vlan 3, port 12 vlan 1.
I have setup up an ip address on interface vlan1 for the switch so that i can manage it. However if i connect a computer up to port 12 with the ip 10.208.0.1, then i can not access the management ip of 10.208.0.253. Do you have any ideas or is there a better way to give the switch a management ip on vlan 1.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...