Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

2950 Switch ROM mode

When power up switch it directly goes in the mode that shows ROM>.

ROM> ?

Commands:

r Read memory

w Write memory

d Dump memory

t Test memory

c Call address

0 Dump CP0 regs

q Quit (return)

ESC Reset system

ROM>

So i am requesting to know how will i come back my switch in normal operation.

Regards

Imran

4 REPLIES
Bronze

Re: 2950 Switch ROM mode

Hi,

Enter ">reset" or "boot" to boot into normal mode.

Usually the switch goes into ROMMON mode due to various reasons like config reg setting changed,ios image corrupted/deleted. Please check n reply.

Rate if it helps..

Regards

*aijaz*

New Member

Re: 2950 Switch ROM mode

Thanks for reply. But "reset" command is not available. Only option is there " Press ESC for reset. When I press ESC it resets but comes again in ROM mode.

Bronze

Re: 2950 Switch ROM mode

Hi,

Can you post the complete booting process information....it might help us..

Thanks...

Re: 2950 Switch ROM mode

Hi,

Post the boot process.

Goutam

373
Views
0
Helpful
4
Replies
CreatePlease to create content