Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2950G log shows Internal POWER supply is FAULTY

Hi Everyone, I've a 2950G that from time to time logs the Internal POWER supply is FAULTY message. The switch is operating normally, it's not rebooting and isn't connected to an RPS. The IOS  version is .121-22.EA8a. Has anyone any idea whether this is a genuine hardware problem or is it software related?

best wishes, Mike

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 2950G log shows Internal POWER supply is FAULTY

Hi Mike,

If 'show env all" does not presents any PS failures, then it could be some cosmetic issue.

For example, could be due to the not fully correct changes in the code

done under CSCsb73608 "2950 does not generate error message when power supply fails",

which in turn were corrected in 12.1(22)EA9 under CSCse84332.

Thanks,

Sergey

4 REPLIES
Cisco Employee

Re: 2950G log shows Internal POWER supply is FAULTY

Hi Mike,

If 'show env all" does not presents any PS failures, then it could be some cosmetic issue.

For example, could be due to the not fully correct changes in the code

done under CSCsb73608 "2950 does not generate error message when power supply fails",

which in turn were corrected in 12.1(22)EA9 under CSCse84332.

Thanks,

Sergey

New Member

Re: 2950G log shows Internal POWER supply is FAULTY

Thanks for your answer Sergey, I'll try the code upgrade

best wishes, Mike

New Member

Re: 2950G log shows Internal POWER supply is FAULTY

Hi,

have you news about this problem ?

I have the same error after upgrade.....last IOS 12.1(22)EA13

thank's for a feedback

regards

New Member

Re: 2950G log shows Internal POWER supply is FAULTY

Hi, the code upgrade didn't fix the problem, the switch has continued to work  but the CLI showed psu fault. We plan to replace the switch just in case the psu suddenly dies, best wishes, Mike

4617
Views
0
Helpful
4
Replies