Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960/2950 cluster conversion

Hi, I have a cisco 2960 as the commander switch with an ip address that is reachable on vlan10 'I had to change the cluster management vlan to 10'. The other 4 switches are 2050's, and are all in a cluster.

When I try using the CNA cluster conversion wizard, I get a 'failed to connect'. My best guess is that the rest of the switches are using vlan 1 as the management cluster vlan?

Any suggestions appreciated

jason.

1 REPLY
New Member

Re: 2960/2950 cluster conversion

Hi, It would seem that all switches must be using the same management-vlan. Here is one point I do not understand.

Using the cli I could not change the management-vlan, it would give me a error stating that only this could only be done on a command switch. I tried changing it using the cna and it worked?

jason

298
Views
0
Helpful
1
Replies