I have a 2960 that is connected to a NetGear router for cable modem access. The netgear gives out IP addresses. I have a WAP with two SSIDs. One ID is PUBLIC and tagged as VLAN 8. The other is PRIVATE and untagged. I can get the untagged SID to connect and get IPs from the netgear. I can get the tagged SID to connect to the WAP, but not getting IPs. I am not sure how to configure the ports on the 2960.
I have updated my diagram to show what I need to happen. Based on what SSID a user attaches to with there laptop, they have access to the corporate lan or public internet access. I cannot get the ports on the switch to allow this to happen. What needs to be set to get it to work.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...