I have two new 2948-48 switches that I need to setup. I am just looking for some advice on setting them up. I want to connect both switches together via cat5 and use one of the gig ports on each switch, then connect one of the gig ports on one of them to the layer 3 switch. Does sound right? Also both switches are in the same vlan.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...