Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960 flex switch stack

2960 switch stack (flex) Spanning tree re-calculate from stack port one?

I need to identify with port in the stack is causing the re-calc I have four 48 port switches and show spanning detail only indicates stack port 1 any ideas to sh which port this is from ?

Sent from Cisco Technical Support iPhone App

1 REPLY
VIP Super Bronze

2960 flex switch stack

Can you post the output of show spanning detail?

If the port is 1/0/1 than that is switch 1 port 1

if the port is 2/0/1 than that is switch 2 port 1

Hopefully, your switches are labeled with the corresponding number, so you know for example switch 4 is the one at the bottom.

HTH

297
Views
0
Helpful
1
Replies