Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2960 internal power supply status and RPS

i have a WS-C2960-24TC-L

with IOS c2960-lanbasek9-mz.150-2.SE4

or IOS c2960-lanbasek9-mz.122-55.SE7

when switch running on dual power RPS+internal

#sh env all

FAN is OK

SYSTEM TEMPERATURE is OK

POWER is OK

RPS is AVAILABLE

when i unplug the RPS cord

#sh env all

FAN is OK

SYSTEM TEMPERATURE is OK

POWER is OK

RPS is NOT PRESENT

when i unplug the power cord from internal power supply

#sh env all

FAN is OK

SYSTEM TEMPERATURE is OK

POWER is OK

RPS is AVAILABLE

on the old model in 2950 it worked fine, it showed POWER is FAIL. I tried three different 2960 switch and is not work.

How do I know that has a failure in the internal power supply?

1 REPLY
New Member

Re: 2960 internal power supply status and RPS

You may have to find a SNMP MIB for the individual power supplies and monitor them. Try to do a snmpwalk from a linux PC on the network. Start with the following OID

.1.3.6.1.4.1.9.1.928

726
Views
0
Helpful
1
Replies