We have two CIsco WS-C2960S-48FPD-L switches. We have stacked them using the Flex Stack technology. We would like to configure layer 2 etherchannels. We need to create 8 etherchannels. As we have read, 2960S switches support up to 6 etherchannel.
When we configure the stack, can we configure up to 12 layer 2 etherchannels? Or, can we only configure 6 etherchannel? In this second case, if we want to configure 8 etherchannel we should not create the stack. Which is the bandwitch when we use a flex stack cable?Are we losing a lot of bandwith if we do not create the stack?
What solution would you suggest? Join them using a 10Gb module?
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...