Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960 Plus switching bandwidth

Hi all,

I was going through datasheets of 2960s/x/plus. I saw in 2960 plus that no value for switching bandwidth is given however its written that switching bandwidth is full duplex capacity

What does this mean

1 REPLY
Cisco Employee

2960 Plus switching bandwidth

Well,

Not mush reason for telling that bandwidth is full duplex w/o a number. I think that missing line

E.G. for 2960X data is following:

Performance and Scalability

2960-X LAN Lite

2960-X LAN Base

2960-XR IP Lite

Forwarding bandwidth

50 Gbps

108 Gbps

108 Gbps

Switching bandwidth*

100 Gbps

216 Gbps

216 Gbps

* Switching bandwidth is full-duplex capacity.

http://www.cisco.com/en/US/prod/collateral/switches/ps5718/ps12995/data_sheet_c78-728232.html

So swithcing bandwidth ine is missing. You can consider that usually multiplying FW rate by 2. Swithicng rate is showing if switch fabric can accomadate both Tx and Rx forwrading rate (if yes then = FW rate * 2).

Niko

345
Views
0
Helpful
1
Replies
CreatePlease login to create content