12-02-2013 01:03 PM - edited 03-07-2019 04:53 PM
I have a 2960 stack with 2 WS-C2960S-48FPD-L distribution switches running c2960s-universalk9-mz.150-2.SE2.bin.
I then have three stand alone 2960S-48 access switches running the same code.
I will have two ten Gig uplinks in a port-channel back to a 6500. I have this config. however
I would like to have port-channel between each of the distribution switches in the stack and each of the stand alone access switches.
So as an example:
distribution switches: port 1/0/48 and 2/0/48 in port channel 1
access switches: 1/0/51 and 1/0/52 in channel-group 1 active
Am I right in thinking that because these port channels come off of two different switches in a 2960 stack that they need to be LACP and the ports on the access switches need to be in "channel-group X active". And does it need to be in active mode on both sides?Solved! Go to Solution.
12-02-2013 01:21 PM
Yes, both sides must have identical channel mode.
12-02-2013 01:21 PM
Yes, both sides must have identical channel mode.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: