2960 stack switches rebooted after Implementing DAI.
I analyzed this issue and this behaving is matching the below DDTS,
CSCts90288 - 2960S stack crashed after "no ip arp inspection" on an interface
The crash occurred after upgrading the code on the 2960 stack from 12.2(55)SE to 12.2(58)SE2. After upgrading the code customer tried entering the command "ip arp inspection trust" or "no ip arp inspection trust" under any interface.
When customer enter either command on a member switch port or a master switch port, all the member switches crash. customer downgraded back to 12.2(55)SE.
The problem is seen only on 15.0(1)SE train, there are no planned rebuild on this branch.
PS: The problem is not seen on 15.0(2)SE train.
*** Please rate if the post is useful ***
*** Please rate if the post useful ***
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...