Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

2960 VLAN Problem

I currently have a 2960 with the following configuration on a fast ethernet port:

switchport access vlan 20

switchport protected.

When this port is connected the config stays the same but when I look at show int status it shows that the port a is TRUNK?

What can I do to stop this port from automatically trunking and what is causing this?

1 REPLY
Hall of Fame Super Blue

Re: 2960 VLAN Problem

Jason

Add this to interface configuration

switchport mode access

Jon

117
Views
0
Helpful
1
Replies
CreatePlease to create content