Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2960G limit bandwidth

I have a 2960G and need to limit the uplink port to 5MB.

2 REPLIES
Bronze

Re: 2960G limit bandwidth

on a box the bandwidth used by the system is 25 percent of the total available bandwidth , this is reserved for routing protocol and control protocols, so a way to overcome that is trying to increment the reserved bandwidth for the system and let a little bit amount of bandwidth for other traffic, the command is maximum-reserved bandwidth...?

check it on the box it functions prety wel on routers .

HTH

do rate if it clarify

Bronze

Re: 2960G limit bandwidth

Hi jobegates,

You can do that by using QoS policing. put in your mind that the exceeded traffic will be dropped "this is depend at your config, but since you are going to rate the traffic to 5MB".

C this

http://www.cisco.com/en/US/tech/tk543/tk545/technologies_tech_note09186a00800d7276.shtml

Please rate if it is helpful!

Thanks

Abd Alqader

150
Views
0
Helpful
2
Replies