02-01-2012 07:55 AM - edited 03-07-2019 04:40 AM
I am going to be connecting my 2960G to another network which will be sending multicast traffic that I need to record on my network. However, due to the administrator of the network I am connecting to, I am not allowed to send them any of our data. Basically, I need to configure a port on my switch that I can connect a feed from them and only recieve data, not send data. Is there an easy way to set this up in the Cisco Network Assistant?
Thanks.
02-08-2012 03:11 AM
Hi,
could you please be a litte more specific?
What kind of data are you not allowed to send? Multicast? Or any data?
What's that 'feed', a multicast source? A router or switch?
Regards,
Michael
02-08-2012 03:32 AM
You need to configure a multicast group and your port will be receiver and their end is the sender.
This link may help you
Eugen
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide