Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

2960G Switch - connected to 4510R - not routing VLAN 40 to VLAN 11 ?

One of our 2960G switches failed, which we replaced but did not have a current config.

Now a user on VLAN 40 cannot access shared drives on VLAN 11 ?

I tried the IP ROUTING command on the 2960G but it is not available.

Other VLANs 30 and 50 can access the VLAN 11 shared drives - why not VLAN 40?

Is there some route blocking on the 4510 switch for the VLAN 40?

Everyone's tags (1)
1 REPLY

check following configuration

check following configuration to be correct:

1- vlan 40: no shutdown

2- trunk port is formed in newly added switch'

3- vlan 40 is allowed on trunk port and not pruned

 

these configurations also must be running on 4510

23
Views
0
Helpful
1
Replies
CreatePlease to create content