Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960G Switch is not able to reload

Dear All,

Recently i have observed that one of my network Switch is not able to reload automatically. Whenever i try to fire RELOAD command it showing following error

Switch#reload

%ERROR: Not able to process Signature in flash:.

%ERROR: Aborting reload.

So kindly help me on this

6 REPLIES

Re: 2960G Switch is not able to reload

Try to disable file verity auto:

Switch(config)#no file verify auto

New Member

Re: 2960G Switch is not able to reload

Its working.

thanks

New Member

Re: 2960G Switch is not able to reload

now it able to reload automatically but once it accept reload command again it move in

Switch: mode and again i need to assign the path of the flash to reload.

New Member

Re: 2960G Switch is not able to reload

What is the switch showing you with:

show boot

Do you have the boot path manually configured in the config file with boot system flash:path_to_image?

You can also verify what's in flash with:

show flash

New Member

I had same problem on 2960X

I had same problem on 2960X stack of 2. I confirmed image was good with:

verify /md5 flash2:/IMAGE.bin

config:

no file verify auto 

worked. Image loaded fine on second unit in stack

Hall of Fame Super Gold

Re: 2960G Switch is not able to reload

What IOS is this? I've never seen this behaviour before.

3521
Views
0
Helpful
6
Replies