2960S and REP

[tomliniker]

Hi there,

I have recently purchased a number of Cisco 2960 S-24TD-L switches and would like to know if they support REP (Resilient Ethernet Protocol). I have set up a development space and have telnet'd on to one of the 2960's to try and configure an Edge Port, but i keep getting the "invalid command" response whenever the word rep is used.

The current software is 12.2 (55) SE7.

Any help would be much appreciated.

Cheers

Tom

[Vasilii Mikhailovskii · Accepted solution]

Hello, Tom.

2960S doesn't support it.

Per my understanding it's an ISP feature, so supported on IE3000, ME and other "ISP featured" IOSs.

[tomliniker]

Hi Mikhailovsky,

Thanks, I think that pretty much clears that up.

I will persue a solution with the ME series of switches.