cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1020
Views
0
Helpful
2
Replies

2960S Flexstack cabling depth

robspain2004
Level 1
Level 1

Hi

I wan to install a 2960S stack in an ADC patch frame that has a wall directly behind it.

I will have about 100mm (4 inches) clearance between the rear of the 2960S and the wall.

Is that sufficient clearance to install/remove the flexstack cables without damaging the cables? (i.e. too tight a turn radius) 

Thanks

Rob Spain

UK

2 Replies 2

Reza Sharifi
Hall of Fame
Hall of Fame

Rob,

It is going to be very tight, because the tip of the flex cable is about 1.5 to 2 inches long. You also need room for you hand to install/remove the cables without damaging them.  Also, with that much clearance, you can not remove the FlexStack module without undoing the switch from the rack.

HTH

Reza

Thanks Reza. Appreciated

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco