Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2960S Flexstack cabling depth

Hi

I wan to install a 2960S stack in an ADC patch frame that has a wall directly behind it.

I will have about 100mm (4 inches) clearance between the rear of the 2960S and the wall.

Is that sufficient clearance to install/remove the flexstack cables without damaging the cables? (i.e. too tight a turn radius) 

Thanks

Rob Spain

UK

Everyone's tags (3)
2 REPLIES
VIP Super Bronze

Re: 2960S Flexstack cabling depth

Rob,

It is going to be very tight, because the tip of the flex cable is about 1.5 to 2 inches long. You also need room for you hand to install/remove the cables without damaging them.  Also, with that much clearance, you can not remove the FlexStack module without undoing the switch from the rack.

HTH

Reza

New Member

Re: 2960S Flexstack cabling depth

Thanks Reza. Appreciated

761
Views
0
Helpful
2
Replies
CreatePlease login to create content