Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

2960s multiple match statements in class map

I have some new WS-C2960S-48FPS-L with 12.2(53)SE2

When I try to add multiple match statements in a class map and apply the service policy to an interface, it come back with

QoS: class(NETMAN) Unsupported classification [GigabitEthernet1/0/47]

NETMAN is the class map name

It works if I limit the match statements to only 1 match statement in the class map

1 REPLY

Re: 2960s multiple match statements in class map

Hello,

I was going through document for 12.2(55)SE and following statement found

Only one ACL per class map and only one match class-map configuration command per class map are supported. The ACL can have multiple ACEs, which match fields against the contents of the packet.

Can you match one statement in class-map and match that class-map in another class-map

like

class-map A

match acl 101

class-map B

match class-map A

match acl 102

You can try as a workaround If it works

Regards

Mahesh

1086
Views
0
Helpful
1
Replies
CreatePlease to create content