Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Bronze

2960S Stack password recovery

Hi,

What's the method to perform password recover on a stack? I aleady have the standard procedure/link to perform on a single switch.

Do I power down both members, disconnect the stack cables, then perform the procedure on the master, then power back down and reconnect the stack and power both back on?

Thanks.

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

2960S Stack password recovery

The entire stack shares the same configuration.  So yes,  you power down the entire stack and do the password recovery on the MASTER.  Then you boot up the remainder of the stack members.

1 REPLY
Hall of Fame Super Gold

2960S Stack password recovery

The entire stack shares the same configuration.  So yes,  you power down the entire stack and do the password recovery on the MASTER.  Then you boot up the remainder of the stack members.

969
Views
0
Helpful
1
Replies