08-11-2014 10:33 PM - edited 03-07-2019 08:21 PM
I have a problem with 4 cisco 2960-s Switches in a stack.
2 of the switches are 2960-48fps-l
1 is a 2960-f48fps-l
and 1 is a 2960-24pd-l
The problem I ran into is the 2960-f48fps-L was running version 15 out of the box so I got a version mismatch when I did a show switch. So i upgraded all 4 switches to the newest ios 15.0.2 when they rebooted now 2 of them say provision and the f48fps does not even show. I have tried everything from moving the cables around to wiping the config on all 4 switch to setting provision setting to setting priority. If I go back to the original version 12.2 on the other 3 switch they all work fine but the oldest version on the f48fps is 15. I have tried everything all with no luck can anyone help?
08-12-2014 05:48 AM
Hi,
Can you make sure that all of the switches use the same SDM template? You can check that with the show sdm prefer command.
Hope this helps.
08-17-2014 09:50 AM
Yes. They to have the default template
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide