I have a Catalyst 6513 at the core. We cut-over four IDF's last evening. The typical IDF follows the following model: A 2960X-48FPD-L at the top of stack with one to four 2960X-48FPS-L in each stack. We are using interface GigabitEthernet 1/0/49 & 1/0/50 (Port-channel) to connect to the 6513 over MMF. All IDF's were up last night night. This morning, two IDF's dropped their connections. We were unable to bring the connections up until we moved the Port-channel to 1Gig interfaces one of the 2960X-48FPS-L switches in the stack. I am wondering if there are any known issues with the 1Gig/10Gig shared ports on the 2960X-48FPD-L switches?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...